1.5 mm Machine Screw Phillips Thin Head Wafer Blue Nylon Patch SS

The 1.5 mm machine screw is usually used on kinds of electronics equipment. The screws have a uniform diameter the entire length of the shaft as opposed to tapered screws that have a pointed tip. Nylon patch is a pre-applied thread-locking coating (typically Nylon), which is fused to internal or external threads of a fastener. Nylon patch is dry to the touch and ready for use right out of the box. Unlike reactive thread lockers, the nylon patch performs immediately upon assembly with no curing time required. Ever Hardware provides the custom-made 1.5 mm machine screw and customizable packaging.

Phillips drive bits are often designated by the letters “PH”, plus a size code 0000, 000, 00, 0, 1, 2, 3, or 4 (by order of increasing size); the numerical bit size codes do not necessarily correspond to nominal screw size numbers.

When assembled with a mating part, the nylon patch is compressed. The engineered plastic (typically a Nylon Patch) resists this compression and acts as a wedge, increasing the metal to metal contact 180° opposite the material. This mechanical force creates a strong, yet fully adjustable lock which will not weaken, even under extreme vibration. Nylon patch screw is commonly known as a prevailing torque type self-locking fastener.

Stainless steel does not readily corrode, rust or stain with water as ordinary steel does. However, it is not fully stain-proof in low-oxygen, high salinity, or poor air-circulation environments. There are different grades and surface finishes of stainless steel to suit the environment the alloy must endure.

Ever Hardware makes the world a better place