Hex Spacer Long Spacer Standoff And Spacer Custom Made

Hex spacer is an unthreaded piece of tubing that lets the entire bolt pass through. Since they cannot be tightened, they are usually round. But hex spacer is much easier to change the direction, so the hex spacer becomes more and more popular in these years. Ever Hardware provides custom-made fasteners and customizable packaging.

A standoff is a threaded separator of defined length used to raise one assembly above another. They are usually round or hex (for wrench tightening), often made of aluminum, brass, or nylon, and come in male-female or female-female forms. In electronics, they are frequently used to raise a printed-circuit board above a surface. Insulating standoffs keep two parts from touching each other, thereby preventing electrical shorts. When used to fasten cable connectors (i.e. “D” connectors) together, they are called “jack screws”.

A lathed spacer can be cutoff and chamfer OD and ID on both ends of a spacer in one chucking. The stationary spacer is gripped by two chucks—one before the rotating cutoff head, one after.
In one continuous operation, we cut, face and chamfer the trailing end of the cut segment and the leading end of the lathed hex spacer being advanced.
The hydraulic chucks and tube feeding system are programmable so you can produce precision parts with no collet or jaw changes. You can cut and chamfer a range of up to 4 inches in diameter with one tool setup.