Screws With Rubber Washers Sealing Washer Locking Washer

Screws with rubber washers are mostly used on electronics, the rubber washer is a sealing washer and prevents the screw to loose at the same time. Ever Hardware provides custom-made fasteners and customizable packaging.

A washer is a thin plate (typically disk-shaped) with a hole (typically in the middle) that is normally used to distribute the load of a threaded fastener, such as a screw or nut. Other uses are as a spacer, spring (Belleville washer, wave washer), wear pad, preload indicating device, locking device, and to reduce vibration (rubber washer). Washers usually have an outer diameter (OD) about twice larger than their inner diameter (ID).
Washers are usually metal or plastic. High-quality bolted joints require hardened steel washers to prevent the loss of pre-load due to Brinelling after the torque is applied.
Rubber or fiber gaskets used in taps (or faucets, or valves) to stop the flow of water are sometimes referred to colloquially as washers; but, while they may look similar, washers and gaskets are usually designed for different functions and made differently.
Washers are also important for preventing galvanic corrosion, particularly by insulating steel screws from aluminum surfaces.

Galvanization, or galvanisation, (or galvanizing as it is most commonly called in that industry), is the process of applying a protective zinc coating to steel or iron, to prevent screws with rubber washers rusting. The most common method is hot-dip galvanizing, in which parts are submerged in a bath of molten zinc. Galvanizing protects in three ways:
It forms a coating of zinc which, when intact, prevents corrosive substances from reaching the underlying steel or iron.
The zinc serves as a sacrificial anode so that even if the coating is scratched, the exposed steel will still be protected by the remaining zinc.
The zinc protects its base metal by corroding before iron. For better results, the application of chromates over zinc is also seen as an industrial trend.