Stainless Steel Truss Head Screws Sheet Metal Plain Finish Phillips Drive Screw Wood TA Self Tapping Passivated Cross Recessed Fasteners Supplier Manufacturer Mushroom M3 M4 M5 Nails

Stainless steel truss head screws are a screw that can tap its own hole as it is driven into the material. For hard substrates such as metal or hard plastics, the self-tapping ability is often created by cutting a gap in the continuity of the thread on the screw, generating a flute, and cutting edge similar to those on a tap. Ever Hardware provides custom-made stainless steel truss head screws and customizable packaging.

Truss head refers to a screw head that is extra wide and has a slightly rounded surface, or top. In other words, the head or top on the screw protrudes just above the surface to be fastened but contains a wider surface area just under the head.
These screws can be used for applications like securing thin membranes, such as one-ply, through insulation. Wooden truss head screws are also commonly used to attach cabinets to steel studs; or to attach sliding shelf supports, since the low-profile head of the truss head screw does not interfere with guide operation.
Truss head screws are well suited for sheet metal and other material with large diameter holes due to their wide head. Additionally, because of their low-dome shaped head, these screws make tampering with or removing the head difficult.

Phillips drive bits are often designated by the letters “PH”, plus a size code 0000, 000, 00, 0, 1, 2, 3, or 4 (by order of increasing size); the numerical bit size codes do not necessarily correspond to nominal screw size numbers.
Stainless steel does not readily corrode, rust or stain with water as ordinary steel does. However, it is not fully stain-proof in low-oxygen, high salinity, or poor air-circulation environments. There are different grades and surface finishes of stainless steel to suit the environment the alloy must endure.

Ever Hardware makes the world a better place