Stand Off Bolts Metric Spacers Standoff Electrical Standoff Fasteners

Stand off bolts also known as standoff, standoff is a threaded separator of defined length used to raise one assembly above another. They are usually round or hex (for wrench tightening), often made of aluminum, brass, or nylon, and come in male-female or female-female forms. In electronics, they are frequently used to raise a printed-circuit board above a surface. Insulating standoffs keep two parts from touching each other, thereby preventing electrical shorts. When used to fasten cable connectors (i.e. “D” connectors) together, they are called “jack screws”.
In contrast, a spacer is an unthreaded piece of tubing that lets the entire bolt pass through. Since they cannot be tightened, they are usually round. Ever Hardware provides custom-made fasteners and customizable packaging.

Stainless steel does not readily corrode, rust or stain with water as ordinary steel does. However, it is not fully stain-proof in low-oxygen, high salinity, or poor air-circulation environments. There are different grades and surface finishes of stainless steel to suit the environment the alloy must endure. Stainless steel is used where both the properties of steel and corrosion resistance are required.
Stainless steel differs from carbon steel by the amount of chromium present. Unprotected carbon steel rusts readily when exposed to air and moisture.

Aluminum is a relatively soft, durable, lightweight, ductile, and malleable metal with appearance ranging from silvery to dull gray, depending on the surface roughness. It is nonmagnetic and does not easily ignite. A fresh film of aluminum serves as a good reflector (approximately 92%) of visible light and an excellent reflector (as much as 98%) of medium and far-infrared radiation.