Push On Fasteners Starlock Quicklock Uncapped Washers Speed Shaft

The push on fasteners or push lock washers is available with or without a decorative cap. The caps hide the end of the axle and push on the fastener when assembled to provide a cosmetic appearance. The standard dome and standard deep axle caps are manufactured from Stainless steel. The extra-deep axle cap is manufacture from steel and electro-zinc plated. The caps can be made from other metals, dependent on material specification and volume required. Ever Hardware provides the custom-made push on fasteners and customizable packaging.

A washer is a thin plate (typically disk-shaped) with a hole (typically in the middle) that is normally used to distribute the load of a threaded fastener, such as a screw or nut. Other uses are as a spacer, spring (Belleville washer, wave washer), wear pad, preload indicating device, locking device, and to reduce vibration (rubber washer). Washers usually have an outer diameter (OD) about twice larger than their inner diameter (ID).
Washers are usually metal or plastic. High-quality bolted joints require hardened steel washers to prevent the loss of pre-load due to Brinelling after the torque is applied.
Rubber or fiber gaskets used in taps (or faucets, or valves) to stop the flow of water are sometimes referred to colloquially as washers; but, while they may look similar, washers and gaskets are usually designed for different functions and made differently.
Washers are also important for preventing galvanic corrosion, particularly by insulating steel screws from aluminum surfaces.

Ever Hardware makes the world a better place